5 Watt audio amplifier


Posted on Sep 12, 2012

The amplifier of circuit, use negative current feedback. So, the load current depends mainly from the input signal and no so much from the impedance of loudspeaker. The inductor current of loudspeaker develop above in the R7 a voltage. This voltage is drive to the inverting input of IC1, creating thus negative feedback. Total voltage gain of circuit, it depend from the reason of impedance of loudspeaker H1 [ Zo ], to the price of R7. In the circuit the gain is (Zo+R7)/R7 that is to say (8+0.5)/0.5=17.. The connection output of IC1 in the ground, is extraordinary, but in this way, the current of base of transistors Q1, Q2 is provided by the lines of supply and no by the IC1.


5 Watt audio amplifier
Click here to download the full size of the above Circuit.

The calm current of is 50 until 100mA, for operation in Class A and is determined by R2, R3, R5, R6. Transistors Q1-Q2, should be matching, so that are not created big current and voltage of deviation. May it will are change the resistors R2, R3, so that we achieve symmetry of bias. With complete drive, the current of emitter the Q1-Q2 is roughly 500mA. The THD is 0.01% for output power, 5W in 8R and voltage supply ± 18V. R1=10Kohm C1=470nF 100V MKT Q1=BD242C R2-3=130ohm C2=22pF ceramic Q2=BD241C R4=68Kohm C3-5=100nF 100V MKT RV1=100Kohm trimmer R5-6=1ohm 1W C4=220nF 100V MKT M1=8ohm >20W Loudspeaker




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    10 Watt Audio Amplifier
    Leak Detector
    Vocal Zapper
    Simple-continuity-tester
    Water Flow Gauge using Arduino
    Wheelchair Obstacle Avoidance System
    Design of the electrical machinery umbilical low-powered stabilized voltage supply
    ethernet Poor eye diagram where to start looking
    6V6 6J5 Class A Vacuum Tube (Valve) Amplifier Circuit
    interfacing lcd with 8051 using keil c at89c51
    Moduler PreamplifierCircuit
    Non-diode rectifier
    Composite CPI amplifier



    Top