Digital Volume Control


Posted on Jul 10, 2012

This digital volume control has no pot to wear out and introduces almost no noise in the circuit. Instead, the volume is controlled by pressing UP and DOWN buttons. This simple circuit would be a great touch to any home audio project.



Digital Volume Control - image 1
Click here to download the full size of the above Image.

C1=0.1uf Ceramic Disc Capacitor U1=DS1669 Digital Pot IC (See Notes) S1, S2=Momentary Push Button Switch MISC=Board, Wire, Socket For U1 Notes: 1. U1 is available from Dallas Semiconductor. 2. S1 turns the volume up, S2 turns it down. 3. The input signal should not fall below -0.2 volts. 4. Using a dual polariity power supply (+-5V works fine) will cure most clipping problems. You will have to check the data sheet for the correct pins to connect your voltages.




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

LM1201 Video Amplifier with Balanced (Bi-Phase) Output
Servo System
op amp monostable multivibrator
accelerometer Can internal PLL affect control logic in MEMS sensor
lm3914 ic based on simple battery tester
small general purpose audio
12V power inverter using 555 timer circuit
Door Ajar Alarm Circuit
Changes inductive boost LED Driver
Three-phase motor overcurrent protection circuit
Single-phase double-winding motor driving
Conducting pipe control rechargeable delay circuit
Dual timing circuit thyristor control table



Top