Audio Line Driver


Posted on Jun 11, 2012

This preamplifier has a low output impedance, and is designed to drive long cables, allowing you to listen to a remote music source without having to buy expensive screened cables. The very low output impedance of around 16 ohms at 1KHz, makes it possible to use ordinary bell wire,loudspeaker or alarm cable for connection. The preamplifier must be placed near the remote music source, for example a CD player. The cable is then run to a remote location where you want to listen. The output of this preamp has a gain of slightly less than one, so an external amplifier must be used to drive loudspeakers.


Audio Line Driver
Click here to download the full size of the above Circuit.




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

Audio Power Limiter
Low Level Sounder Circuit
how to make simple earthquake sensor
cheap motors with arduino
A simple passive logarithmic VU-meter
fet amp circuit
gizDuino Hardware
H-bridge
Single Button Force Sensing Resistor
Loudspeaking radio receiver with a bridge amplifier powered by free energy



Top