Instrument preamp


Posted on Dec 19, 2012

The input impedance is the value of potentiometer Rl. If your instrument has extra-deep bass, change capacitor Cl to 0.5 mF. What appears to be an extra part in the feedback loop is a brightening tone control. The basic feedback from the op amp's output (pin 6) to the inverting input (pin 2) consists of resistor R7, and the series connection of resistor R4 and capacitor C3, which produce a voltage gain of almost 5 (almost 14 dB). That should be more extra oomph than usually needed.


Instrument preamp
Click here to download the full size of the above Circuit.

If the circuit is somewhat short on bass response, increase the value of capacitor C3 to 1 to 10 µ. Start with 1 µ¥ and increase the value until you get the bass effect you want.




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

Sound Level Indicator LM3915
Touch switch
how to make simple active low pass
car parking sensor circuit using infra
car subwoofer filter using op
SDK03M 2-Phase Stepper Motor Unipolar Driver ICs
10W Audio Amplifier With Bass-Boost
thermometer circuit
DA-101 FM radio circuit chip
Three motor control circuit start and stop sequence requirements
Electric shaver circuit



Top