Tube dual opamp


Posted on Jul 3, 2012

Here are photos of a tube unit including an analog multiplier, phase discriminator and a relay control driver (a big relay was inserted in a socket near two potentiometers on the left). Used in ground control gear (don`t ask me - control of what..., all I know it`s ground, not mobile, piece). Chassis is machined of a solid aluminum piece - 31*12*5 cm. There`s a total of nine miniature tubes (2 RF pentodes, 7 dual triodes). The compartments on the left, top right and bottom right are normally covered with tin lids, so the whole unit is one smooth brick with a window in it.



These units are stacked vertically in a rack, windows form a chimney for air cooling. The thing ran on a low B+ - all caps are 160V rated, the largest resistors 1W rated. Note the daisy-chained heater bus (white-blue wires) - something you don`t want




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

Phone Bill Calculator
Precise audio clipper
Dual limit comparator
Demultiplexer
12V Car Battery Charger
Electronic Buzzer with IC timer NE555 circuit diagram
The uTracer V3 a miniature Tube Curve Tracer
Coop automatically fill light circuit
Electronics - circuit relay type answer
Detected line current Phase protective circuit 2
Based on Bluetooth wireless transmission-reception circuit design schematics
Vehicle lights at night rendezvous controlled circuit
Class push-pull tube power amplifier circuit diagram 2A3A



Top