0-30 VDC Stabilized Power Supply with Current Control 0.002-3 A


Posted on Feb 5, 2014

To start with, there is a step-down mains transformer with a secondary winding rated at 24 V/3 A, which is connected across the input points of the circuit at pins 1 & 2. (the quality of the supplies output will be directly proportional to the quality of the transformer). The AC voltage of the transformers secondary winding is rectified by the bri


0-30 VDC Stabilized Power Supply with Current Control 0.002-3 A
Click here to download the full size of the above Circuit.

dge formed by the four diodes D1-D4. The DC voltage taken across the output of the bridge is smoothed by the filter formed by the reservoir capacitor C1 and the resistor R1. The circuit incorporates some unique features which make it quite different from other power supplies of its class. Instead of using a variable feedback arrangement to control the output voltage, our circuit uses a constant gain amplifier to provide the reference voltage necessary for its stable operation. The reference voltage is generated at the output of U1. The circuit operates as follows: The diode D8 is a 5. 6 V zener, which here operates at its zero temperature coefficient current. The voltage in the output of U1 gradually increases till the diode D8 is turned on. When this happens the circuit stabilises and the Zener reference voltage (5. 6 V) appears across the resistor R5. The current which flows through the non inverting input of the op-amp is negligible, therefore the same current flows through R5 and R6, and as the two resistors have the same value the voltage across the two of them in series will be exactly twice the voltage across each one. Thus the voltage present at the output of the op-amp (pin 6 of U1) is 11. 2 V, twice the zeners reference voltage. The integrated circuit U2 has a constant amplification factor of approximately 3 X, according to the formula A=(R11+R12)/R11, and raises the 11. 2 V reference voltage to approximately 33...




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    Brightness Control for small Lamps
    AVR LCD Microcontrolled Oscilloscope
    Temperature meter
    Low-Power Antenna Tuner Circuit
    Add 12V Output To 5V Buck Regulator Circuit
    Car Boot Lamp Warning (ICM7556)
    Bridged amplifier circuit diagram of LM4065
    555 double coil metal detectors
    Construction and operation of the brushless motor windings principle e



    Top