Active Antenna for Medium Wave


Posted on Feb 5, 2014

This circuit is designed to amplify the input from a telescopic whip antenna. The preamplifier is designed to cover the medium waveband from about 550Khz to 1650Khz. The tuning voltage required is 1 to 12 volts and can be obtained from a 10k potentiometer connected to the 12 Volt power supply. RV1 is the gain control allowing weak signals to be am


Active Antenna for Medium Wave
Click here to download the full size of the above Circuit.

plified or strong signals to be attenuated. The control voltage is applied to gate 2 of TR1, a dual-gate MOSFET, the signal voltage applied via gate 1; the input signal being tuned via L1 and the two varicap diodes at the MOSFET`s input and also by L2 and the varicaps at the MOSFET`s drain terminal. Both tuned circuits provide high selectivity across the entire tuning range. To aid stability the MOSFET stage is fed from a stabilized supply consisting of ZD1 and R6. To drive low impedance (50 ohm) receivers, the medium output imepedance of the BF981 stage is enhanced by the composite amplifier made from TR2 and TR3. TR2 is operating in common emitter boosting voltage levels by just over 2, TR3 is operating in emitter follower giving the circuit a low output impedance. Finally this active antenna can be used on other bands by changing the values of L1 and L2. To perform on multiple bands switches or relays can be used to change the value of L1 and L2.




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    PIC16CS4 Programmer
    Bandpass and notch filter
    Tachless-motor-speed-controller
    Mixer Diplexer
    wireless picaxe based water tank level sensor
    Night Light circuit
    Clock synchronization circuit diagram
    Digital tachometer schematic
    Nine-digit password composed of the controller circuit diagram CD4017
    Simple Valve MW Transmitter circuit 30W



    Top