Enhanced 4 Digit Alarm Keypad


Posted on Feb 7, 2014

The Keypad must be the kind with a common terminal and a separate connection for each key. On a 12-key pad, look for 13 terminals. The matrix type with 7 terminals will NOT do. The Alarm is set by pressing a single key. Choose the key you want to use and wire it to `E`. Choose the four keys you want to use to switch the alarm off, and connect them


Enhanced 4 Digit Alarm Keypad
Click here to download the full size of the above Circuit.

to `A B C & D`. Your code can include the non-numeric symbols. With a 12-key pad, over 10 000 different codes are available. Wire the common to R1 and all the remaining keys to `F`. When `E` is pressed, current through D2 and R9 switches Q5 on. The relay energises, and then holds itself on by providing base current for Q5 through R10. The 12-volt output is switched from the "off " to the "set " terminal, and the LED lights. To switch the Alarm off again it is necessary to press A, B, C & D in the right order. The IC is a quad 2-input AND gate, a Cmos 4081. These gates only produce a high output when both inputs are high. Pin 1 is held high by R5. This `enables` gate 1, so that when `A` is pressed, the output at pin 3 will go high. This output does two jobs. It locks itself high using R2 and it enables gate 2 by taking pin 5 high. The remaining gates operate in the same way, each locking itself on through a resistor and enabling its successor. If the correct code is entered, pin 10 will switch Q4 on and so connect the base of Q5 to ground. This causes Q5 to switch off and the relay to drop out. Any keys not wired to `A B C D or E` are connected to the base of Q3 by R7. Whenever one of these `wrong` keys is pressed, Q3 takes pin 1 low. This removes the `enable` from gate 1, and the code entry process fails. If `C` or `D` is pressed out of sequence, Q1 or Q2 will also take pin 1 low, with the same result. You can change the...




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    Wireless Coupler
    Light-seeking robot
    Touch Switch Circuit
    DIY ECC802S (12AU7 / ECC82) Vacuum Tube SRPP Preamplifier
    DS1621 IIC interface under Linux drives designing
    the active power factor correction (PFC) of FAN4810 Circuit design
    Triple Power Supply
    Utility Power Supply
    volume controller equalizer
    TS4962 3W Filter-free Class D Audio Power Amplifier With Active Low Standby Mode
    RAZOR SHARP CW FILTER
    Infra/radio remote control encoder/decoder with PIC
    Clamp stay current probe compensator



    Top