LED Lighting For Consumer Unit Cupboard


Posted on Feb 4, 2014

The consumer unit (or electricity meter`) cupboard in some older houses is a badly lit place. If the bell transformer is also located in this cupboard, it may be used to provide emergency lighting by two high-current LEDs. These diodes are powered via a small circuit that switches over to four NiCd batteries when the mains fails. The output voltag


LED Lighting For Consumer Unit Cupboard
Click here to download the full size of the above Circuit.

e of the bell transformer is rectified by bridge B1 and buffered by capacitor C1. The batteries are charged continuously with a current of about 7. 5 mA via diode D1 and resistor R2. The base of transistor T1 is high via R3, so that the transistor is cut off. When the mains voltage fails, C1 is discharged via R1; when the potential across it has dropped to a given value, the battery voltage switches on T1 via R3 and R1, provided switch S1 is closed. When T1 is on, a current of some 20 mA flows through diodes D4 and D5. The light from these LEDs is sufficient to enable the defect fuse or the tripped circuit breaker to be located.




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    Telephone-amplifier
    Electronic Thermostat Circuit
    ADM660 Charge Pump Voltage Inverter Circuit Configuration and Datasheet
    LCC configuration for Tesla Coil impedance circuit
    Tachometer circuit diagram of a multiplier



    Top