Simple audio mixer circuit with fet 2n3819


Posted on Feb 4, 2014

This circuit, a simple mixer circuit. It can mix two signal channels and one channel is output. Using a codec circuit, Convert stereo audio to mono audio time. It can increase the number of channels too. By adding a VR1, R1 and C1 to the amount needed. Then connected to Buffett a new one. Most importantly is eating circuit current is very low. Can use


Simple audio mixer circuit with fet 2n3819
Click here to download the full size of the above Circuit.

with 9-volt batteries immediately. When entering voice signal, one of input 1 and input 2. Audio is via C1 and C2 of each channel, served coupling signals to VR1 and VR2. To adjust the audio to the Fet Q1. Which it serves, including audio. Then expand signal the output pin S through C3 For coupling signal again, before leaving to the output.




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

LED Bike Light Circuit Project
Bat Feed GO
Motion Sensor Light Circuit
Homemade Phone PBX
THE ZX97LITE SCHEMATIC
For frequent motor starting Y- starting circuit
555 ultra-low frequency signal generator circuit diagram of a millivolt
Bridge voltage regulator circuit diagram using the



Top