Solar Cell Voltage Regulator circuit


Posted on Feb 5, 2014

This device is designed to be a simple, inexpensive ˜comparator, intended for use in a solar cell power supply setup where a quick ˜too low or ˜just right voltage indicator is needed. The circuit consists only of one 5V regulator, two transistors, two LEDs, five resistors, two capacitors, and one small battery. Although a 4-V battery is indicated, 4.5 V (3 alkalines in series) or 3.6 V (3 NiCd cells in series) will also work..


Solar Cell Voltage Regulator circuit
Click here to download the full size of the above Circuit.




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    Optimized 6/9 element VHF Yagi Antenna
    Cat / Dog Detector
    Triangle-to-sine converters
    Wideband Preamp Circuit
    Low cost Ethernet shield with ENC28J60 using Arduino
    Schematic Diagram 250mW 16-dB VHF amplifier circuit
    Infrared proximity sensor serial Si1143 of Silicon Labs Company
    Infrared Transmitter-Receiver with 555
    Electronics/Transmitter design
    temp control circuit
    high current mosfet toggle switch
    pong reborn
    water liquid level sensor relay switch
    555 Timer as Monostable Multivibrator
    Single Meter Clocks
    Simple Water Detector Circuit
    H-bridge of 40N60 mini-brick IGBTs
    Ensemble II VHF RX rf
    Low power monostable circuit diagram
    Discharge After the memory circuit



    Top