bicycle back safety light


Posted on Feb 6, 2014

This circuit has been designed to provide a clearly visible light, formed by 13 high efficiency flashing LEDs arranged in a pseudo-rotating order. Due to low voltage, low drain battery operation and small size, the device is suitable for mounting on bicycles as a back light, or to put on by jogger/walkers. IC1 is a CMos version of the 555 IC wired


bicycle back safety light
Click here to download the full size of the above Circuit.

as an astable multivibrator generating a 50% duty-cycle square wave at about 4Hz frequency. At 3V supply, 555 output (pin 3) sinking current operation is far better than sourcing, then LEDs D1-D6 are connected to the positive supply rail. In order to obtain an alternate flashing operation, a second 555 IC is provided, acting as a trigger plus inverter and driving LEDs D7-D12. D13 is permanently on. The LEDs are arranged in a two series display as shown below, with a center LED permanently on. This arrangement and the alternate flashing of the two series of LEDs provide a pseudo-rotating appearance.




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    915-MHz antenna monopole
    Pwm-motor-controller
    Transistor Turns Op Amp On Or Off
    ultrasonic mosquito repeller
    Lamp flasher using LM317
    Mic2290 48v Avalanche Photo Diode (apd) Application Circuit W/ 0603 Chip Inductor
    A small FM transmitter (SMD)s
    Mini audio amplifier circuit
    5V Power Supply For On-Train Radio Camera
    High-speed integrator circuit (LM101A, LM108)



    Top