economy radar detector


Posted on Feb 7, 2014

This circuit uses a 1458 dual op-amp to form a radar detector. C1 is the detector of the radar signal. The first op-amp forms a current-to-voltage converter and the second op-amp buffers the output to drive the piezo transducer. R5 sets the switching threshold of the second op-amp; normally it is adjusted so that the circuit barely triggers on bac


economy radar detector
Click here to download the full size of the above Circuit.

kground noise, then it`s backed off a bit. The response of the circuit may be tuned by adjusting the length of the leads on C1. For typical road-radar systems, the input capacitor`s leads should be about 0. 5 to 0. 6 inches




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

Servo motor Tester with PIC12F675
Picture-fixer-inverter
Frequency Divider For Measurements Circuit
4 order filter with a single IC project PCB
Phase Locked Loop (PLL) Oscillator Circuit 860 MHz
AUTO ALARM
Charge amplifier circuit
125 Motorcycle electronic ignition circuit diagram



Top