Murray Crystal
#crystal oscillator
#frequency generator
#timing circuit
#quartz crystal
#clock signal
#electronic oscillator
#precision timing
#resonator
#frequency stability
#sine wave
No description available.
SEL2411AA Crystal Clock Oscillator 3.3 & 5V High Frequency ECL
The SI2171 is a sub-package of the SI2170. For further details, please refer to the SI2170 description. The datasheet for the SI2171 can be downloaded from the link provided below. By Silicon Laboratories.
The SI2171 is a versatile integrated circuit designed...
Wien bridge sine wave oscillator circuit composed of LM101A
The chart illustrates the Wien bridge sine wave oscillator circuit. The amount of negative feedback in the circuit is determined by the internal resistance of the FET. When the peak output voltage of the oscillator reaches the regulated voltage of...
Precision Metronome/Pitch
Precision Frequency generator 1 to 999 Hz Precision Metronome 1 to 999 beats per minute. CMos IC1 and IC2B quad AND gate form a 2.4576 MHz crystal oscillator plus a 2400 times divider. IC3A provides further division by 16, delivering...
oscillator circuits
This generally results in a square wave if the frequency of oscillation is low enough relative to the amplifier's bandwidth. The schematic of a crystal-controlled oscillator features a low-frequency sine wave oscillator characterized by low distortion, wideband operation, and crystal...
A low noise four phase crystal oscillator
A 10 MHz crystal typically exhibits an impedance of 4 ohms at its series resonance and 40 kiloohms at its parallel resonance. To minimize sideband noise, the power dissipated in the crystal must be substantial; the design presented here dissipates...
Self Powered Sine Wave to Square Converter
This circuit utilizes a single active component, the 4069 IC, to convert sine waves into square waves without requiring an external power source. It is designed for testing audio instruments.
The circuit leverages the characteristics of the 4069 IC, which is...
Crystal oscillator DTL integrated circuit
A crystal oscillator is implemented using a DTL (Diode-Transistor Logic) integrated circuit. The oscillation frequencies are 100 kHz and 1 MHz. The circuit consists of a gate circuit that generates a signal for the oscillator circuitry in DTL.
The crystal oscillator...
Wien oscillator
Construct a sine wave generator using the TL082 operational amplifier and a 9V power supply. However, the output is producing a distorted waveform rather than a clean sine wave. There is a need for a list of components suitable for...
Circuit Crystal Oscillator/Amplifier
This oscillator is a variation of the oscillator presented by Ulrich L. Rohde, DJ2LR, in his article "Evaluating Noise Sideband Performance in Oscillators," published in Ham Radio, October 1978, Page 51. The original circuit can be found at the bottom...