Runtime Power Control For Dsps Using The Tps6200 Buck Converter
#buck converter
#TPS6200
#DSP
#power management
#voltage regulation
#switching
#energy efficiency
#DC-DC converter
#embedded systems
#low power
No description available.
Single Cell Battery 1.5V 20dB Inverting Amplifier
This amplifier circuit exhibits a very low power consumption, with a total current draw of 675 nA. The output voltage swing is 300 mV peak-to-peak (pp) with a gain of 20.
The amplifier circuit is designed to operate with minimal power...
Dc to Dc converter using 555 Timer IC
When the power supply is connected to IC1, the output pin 3 operates at a frequency of 1 kHz. The components Q1 and Q2 work in a push-pull configuration. When a positive output signal is generated, Q1 and Q2 execute...
3 to 12 volts step up DC converter using MAX668
3 to 12 volts step-up DC converter using MAX668 integrated circuit design
The circuit described is a step-up (boost) DC-DC converter designed to convert an input voltage in the range of 3 to 12 volts into a higher output voltage. The...
power Voltage supply clipping to <=3.3V
Supply it with a Li-Ion cell, which has a voltage range of 2.7 to 4.2V. The complexity of a buck/boost converter is not desired. While it is possible to regulate the voltage down to anything below 2.5V, it would be...
dsp sstc
This project involves the development of a versatile digital signal processor (DSP) based generic driver and controller circuit for Solid State Tesla Coils (SSTCs). It is designed to support various topologies, including DRSSTC, OLTC, and PLL-SSTC, which can be implemented...
Low Power Regulator Reference
This is a simple circuit of a low-power voltage regulator reference. This circuit can produce a stable voltage reference.
The low-power voltage regulator reference circuit is designed to provide a consistent output voltage, which is crucial for various electronic applications requiring...
+5V + 12V boost power supply MAX761
The circuit depicted in the figure illustrates an efficient, low-power step-up DC-DC converter, the MAX761, along with a few external components, which functions as a +5V to +12V boost power supply. Its characteristics include a conversion efficiency of 86% and...
100v / 10ma regulator circuit
The circuit features no-load and short circuit protection mechanisms. To accommodate short circuit conditions, it is necessary to increase resistors R1 and R2 to allow for power dissipation; for example, R1 can be set to 1.2kΩ with a power rating...
LMZ13608 8A switching power supply circuit design
A simple, high-efficiency switching power supply circuit can be designed using the LMZ13608 8A regulator. This regulator offers very high efficiency and requires few external components. It supports a wide input voltage range of 6 to 36 volts and provides...