RF Jammer Diagram
#RF
#jammer
#signal interference
#wireless
#transmitter
#receiver
#frequency
#electronics
#communication
#security
No description available.
Security alarm
This alarm features both open-loop and closed-loop detection systems along with an automatic alarm shutoff mechanism. It provides a 15-second delay for exit and entrance. Additionally, the alarm activation time can be adjusted from 1 to 15 minutes.
The alarm system...
Wireless-fm-microphone
An adjustable capacitor C10 and a coil L1 create a tank circuit that, along with Q1, C2, and R1, oscillates at a frequency within the FM band. The center frequency is adjustable by tuning C10. An electret microphone, M1, captures...
RF oscillator circuit (2N3904)
This basic RF oscillator circuit is easy to build and the components are not critical. Most of them can be found in your junk parts box. The L1 antenna coil can be made by close winding 8 to 10 turns...
JAMCAT
This is a simple add-on jammer adapter for any amateur or two-way radio transceiver with an external microphone (PTT) and earphone/speaker connection. The jammer will transmit the radio upon detecting any activity on the frequency to which the receiver is...
6m wireless remote control switch circuit
This example describes a wireless remote control switch featuring reliable operation and practical characteristics, capable of remotely controlling a 6-channel device within a 6-meter range for household electricity. The wireless remote control switch circuit consists of a wireless transmitter and...
Tuned Rf Wavemeter
L1 and L2 form a tuned transformer with an optimum turns ratio of approximately 1:3. L2 and C1 are used to tune to the desired frequency. The frequency range can extend from 10 kHz to over 200 MHz, depending on...
RF communication use a sample circuit(example in AVR)
Even including labor, the actual cost of purchasing, stocking, assembly, assembly errors, more expensive PCBs (with additional holes and larger sizes), and the increased difficulty in tuning would likely result in significantly higher expenses.
The analysis of costs associated with electronic...
RF Remote Control Encoder and Decoder Chips Explained
Creating a universal remote control system has become quite straightforward. One can acquire the necessary chips, assemble them, and the high-tech remote control device will be operational. This document discusses specific remote control chips designed for this purpose. The IC...
TV and FM jammer schematic
The Jammer is a very small circuit and can fit inside a small plastic box with 9V battery inside. It can be very illegal if you attach an external antenna so don't. adjust frequency by turning trimmer. It is intended...