Fiberoptic interface


Posted on Sep 5, 2012

An op amp is used to interface between a fiberoptic system and the MOS SCR to multi-cycle, half-wave control of a load. This receiver has two complementary outputs, one at a quiescent level of about 0.6 V and the second at 3 V. By adding a 4.7 V zener in series with the return bus, the effective VqC becomes 5.3 V and also the 0.6 V output level is translated up to about 5.3 V.


Fiberoptic interface
Click here to download the full size of the above Circuit.

This level is compatible with the reference input (5.9 V) of the single-ended powered op-amp acting as a comparator.




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

All transistor microphone pre-amplifier
Temperature meter
Proximity-switch
Mole Deterrent Teardown
alarm door bell circuit using ic um 66 part 1
The Forward Converter
remote_control circuit
555 Pulse generator
Single 10 Shunt Fed Hartley Oscillator for 80 meter CW
Flight Computer Assembly Instructions
One simple charging circuit b porcelain
Auto Cutter mill circuit



Top