Adjustable power supply using LM317


Posted on Jun 15, 2012

R2 = (192 x Vout) - 240, where R2 in ohms, Vout is in volts and must be at between 1.2 V and 35 V. Vin should be at least 2.5V greater than Vout. Select a wall adapter with a voltage at least 2.5 V greater than your regulated output at full load. Maximum output current is 1 A. Use proper heatsink for LM317 if it has to dissipate more than 1W. The tab of the LM317 is connected to the center pin.






Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

Interactive Voice Response System
Auto Fuse for power supply
Telephone Line Controller
Electronic Siren with 2 transistors
860 Watt limited-range light control
the water level control system design of the one-chip computer
Scientific Society
power failure alarm circuit
televition transmitter
computer-circuits
Stepper motor controller - Driver circuit with circuit design
Cuckoo sound Generators
Electrical Systems and Circuits
Microcontroller Clocking a Transmitter?
Electronic VU Meter



Top