This is the timekeeping test circuit. It includes a one-transistor circuit to switch in the 5V power supply when present and drop back to the 3v battery the rest of the time. That loop of blue wire-wrapping wire is a lariat used to quickly and easily pull....

The Lazy Adapter is composed of a 20 pin DIP socket, a 20 pin DIP header, and 6 pin ISP header, and a small phenolic circuit board to hold them all together. The green fiberglass PCB is a Dontronics DT104 SIMSTIC(This plug is in return for a favor.) I am....

Plug an ATtiny12 into the 8 pin socket and hold down "GO!" button. The LED will come on at the end of the programming process, which only takes a couple hundred millisecond. The fuses are now restored to their factory default states. This picture was taken....

This handy breadboard header for ATTiny 25/45/85 microcontroller is a new design based on the original idea from Tinkerlog. Maybe the most useful feature is that it can provide power to the vertical breadboard strips while connecting all six port pins to the....

You can connect seven-segment LCDs using only a two-wire interface (Figure 1). The two-wire interface may be at the field-effect, direct-drive LCD or at a serial interface (such as I2C) that uses an eight-pin microcontroller. The design in Figure 1 uses an....

Just the solution for AVR applications in which I/O is tight, such as the ATtiny12. This should work well on other kids of controllers that have independently controlled I/O direction registers, such as PIC and 6805 controllers. This is a solution was....

A frequency reference for tuning up the RS-232 to 100 MHz RF desktop channel adapter elsewhere on this site, when I found this Saronix crystal oscillator in my junk box. A few minutes with AVRStudio produced an ATtiny12 to make a tone - even fewer parts....

This circuit based on ATtiny26 but it could be anyone microcontroller of AVR family. Produce stable one MIDI tone and you can change it by press some keys like to change midi channel 0-15 , velocity 0-127, pitch 0-127. It is start from center tone (C) at....

1 kHz is a commonly used test frequency, and I resolved to see if I could make an inductance meter that uses a 1 kHz test signal at a low level. I also wanted to use a low level test signal so that the test current would have a minimal effect on the....

Use of IR (infrared) light as a method for wireless communication has become popular for remote control applications. There are a number of different standards for such communication. In this application note the widely used RC5 coding scheme from Philips....

The 040904C version of the code has a larger UART receive buffer and supports two pushbuttons that send either and ASCII "R" ($52) or an ASCII carriage Something to keep in mind when using AVR controllers that support 16 bit addressing(specifically, the....

If this picture (above) looks a lot like the Pretty Good LC Meter also on this web site, that's because its the same meter, but with some significant improvements. At this point, its a good idea to read the Pretty Good LC Meter page because the rest of this....

(Almost) Trivial application of an AT90S2313 or ATtiny2313 in an alarm clock to change the alarm from "BEEP BEEP BEEP BEEP BEEP BEEP BEEP BEEP..." to "WAKE UP" in Morse code. This was designed in response to a request and is in daily use. An inexpensive....